Ventricular tachycardia ablation is done in the hospital. Before the procedure, you usually get a medicine called a sedative that helps you relax.
The amount of sedation needed for the procedure depends on the specific type of irregular heartbeat and your overall health. You may be fully awake or lightly sedated. Some people get a combination of medicines, called general anesthesia, to put them in a sleep-like state.
The doctor inserts a long flexible tube called a catheter into a blood vessel, usually in the groin area. The catheter is gently guided to the heart.
Sensors on the tip of the catheter send electrical signals and record the heart's electricity. Your care team uses this information to determine the best place to apply the VT ablation treatment.
One of the following ablation techniques is used to create small scars in the heart and block irregular heart rhythms.
- Heat, known as radiofrequency energy.
- Extreme cold, known as cryoablation.
VT ablation may be done from inside or outside the heart. Sometimes, treatment is done at both locations.
- Inside the heart. If the irregular heartbeat is coming from inside the heart, the doctor guides the catheter to this area. Heat or cold energy is applied to the target area. The energy damages the tissue and causes scarring. This helps block the electrical signals that cause ventricular tachycardia.
- Outside the heart, also called epicardial ablation. If the irregular heartbeat starts in tissue outside the heart, the doctor places a needle through the skin on the chest and into the lining of the fluid-filled sack around the heart. A hollow tube called a sheath is then inserted. Flexible tubes called catheters go through the sheath to access the outside surface of the heart. Heat or cold energy can be used during epicardial ablation.
VT ablation takes about 3 to 6 hours. Afterward, you go to a recovery area where a care team closely watches you. You may stay overnight in the hospital.